Reduce the drawbacks of the conveyor belt

Conveyor belt production of skeleton information needs appropriate targeted, not the same function of the conveyor belt canvas skeleton information has a special demand, can not mix, otherwise it will form a variety of conveyor belt problems. Skeleton of the twists and turns of the decision of the canvas stretch slightly, we have to pay special attention. Here to explain the conveyor belt bending down the questions brought about by the decline.

1. Conveyor belt at the bottom of a simple wrinkle, resulting in a simple conveyor belt delamination and so on. Because the rubber conveyor belt twists and turns, the bottom of the rubber and skeleton data because of tightening deformation, shear stress ups and downs, the formation of rubber and skeleton material interface was damaged, and the top layer will be a long time between the A separate effect of the force, and ultimately lead to delamination. Because the bottom of the conveyor belt is wrinkled, the touch between the conveyor belt and the roller is no longer a touch of the cotton, but the line touches, the power transmission receives a great influence and is simply slipping; this line also forms the rubber on the conveyor belt In the effect of the drum, the rubber was "bitten off".

2. hard work down.

  Skeleton data in the tightening of the tensile effect of the tension in the only change in the size of the tensile stress compared to the effect, even if the change in ups and downs, the former resistance to fatigue will be significantly reduced.

3. The impact resistance of the conveyor belt is reduced.

    The impact of the conveyor belt bumps, and the structure of the canvas are closely linked. Usually the canvas of the meridional meandering decline, usually means that the canvas zigzag progress. We can analyze the current canvas warp and weft of the twists and turns, you can know, weft is in a very relaxed situation. If the weft is in a tortuous condition, when the material impact canvas, the impact force mainly by the tension in the warp of the force, and the weft will only bend some elongation Bale, no force, it will not pull the impact point outside the warp Force, obviously impact resistance is poor. If the weft yarn is in a tense condition and the warp yarns are in a relaxed condition and the impact force is applied, the weft force is resistant to deformation, and then the adjacent warp yarns are deformed and the impact force is gradually transmitted, which is in the direction of the trampoline Spring fixed, will have to meet the same flexibility. So we must enhance the bend of the conveyor belt canvas, in order to improve the tensile strength of the conveyor belt.